GitHub DLC32 Firmware Programming Instruction Manual

GitHub DLC32 Firmware Programming

وصف

• The purpose of this document is to explain that the process for customers to update the firmware of the DLc32 motherboard is simpler and easier to understand

تثبيت البرامج

1. lnstall “MKSlaserTool-setup Vl.x.x”
2. تثبيت برنامج تشغيل CH340 file (if your PC has already been installed, please skip this link)ملحوظة:lf the PC has not installed ch340, the motherboard connected to the PC cannot be recognized and connected to DLC32

Software programming operation process

1. Open the MKS LASER TOOL software and connect DLC32 to the PC
2. Set DLC32 parameters

إعداد المعلمات

• SPI SPEED: 80MHZ
• FLASH SIZE: 8MB
• معدل باود: 115200
• Serial port (COM): This assigns the com of the motherboard according to the PC.This is after the CH340 driverfile is installed in the previous step, the motherboard will be allocated. The motherboard in the picture is assigned “coM15”.lf you don’t know the serial number, you can check it in the Device Manager.
  (ملحوظة: The serial number is not fixed, if you connect to another PC, this may change)Select DLC32 motherboard firmware to update
• The process is shown in the picture above. When the software shows that the update is successful, you only need to unplug the USB cable and power on again.

If there is any problem during use. You can leave a message on our GitHub or Facebook.

• FACEBoOk:https://www.facebook.com/Makerbase.mks/
• GITHUB:https://github.com/makerbase-mks/MKS-DLC32
• علي اكسبريس:https://www.aliexpress.com/store/1047297