JoJo Booster Pump Flow Controller
تحديد
- اسم المنتج: JoJo Booster Pump Flow Controller
- متوافق مع: JoJo Booster Pumps
- قطعة بديلة: JoJo PC Board
- الأدوات المطلوبة: STAR SCREW DRIVER
سوف تحتاج إلى ما يلي:
ملحوظة: Our Booster Pump PC Board is only suited for use with the following JoJo
Booster Pumps:
- 0.37kW مضخة معززة
- 0.55kW, 0.75kW & 1.1kW
- مضخات الطرد المركزي
- 0.6kW مضخة نفاثة ذاتية التحضير
تعليمات استخدام المنتج
الخطوة 1
Ensure that your pump is disconnected from the power source.
الخطوة 2
Unscrew the four screws holding the terminal box cover in place.
الخطوة 3
قم بإزالة غطاء صندوق الأطراف.
الخطوة 4
Disconnect the wires from the terminals and remove from the terminal box.
الخطوة 5
Unscrew the two screws holding the PC Board in place.
الخطوة 6
قم بإزالة لوحة الكمبيوتر.
الخطوة 7
Insert the replacement JoJo PC Board.
الخطوة 8
Insert and fasten the two securing screws on both sides of the PC Board.
الخطوة 9
Secure the wires to the terminals as follows:
- the wires from the pump through the bottom grommet
- the wires from the three-point plug through the top grommet.
ملحوظة: ensure that the correct color sequence is followed as shown below
الخطوة 10
Replace the terminal box cover, and fasten the four screws holding it in place.
الخطوة 11
Your pump is now ready for use and reconnection to your power supply.
Scan the QR Code to watch the instructional video for visual guidance.
التعليمات
Can I use the JoJo Replacement PC Board with other pumps?
Our Booster Pump PC Board is only suited for use with JoJo Booster Pumps.
المستندات / الموارد
 |
JoJo Booster Pump Flow Controller [بي دي اف] دليل المستخدم Booster Pump Flow Controller, Pump Flow Controller, Flow Controller, Controller |