Hiway-logo

Hiway Integrated Circuit HW48244 TPMS Sensor

Hiway-Integrated-Circuit-HW48244-tPMS-Sensor-product

اسم المنتج
TPMS SENSOR—Part No.:HW48244-SGY-100

ملخص الوظيفة
Regularly measure the tire pressure and temperature, and monitor the motion of the tire.

مواصفات المنتج

  • Operating Temperature -40℃~125℃
  • درجة حرارة التخزين -40 درجة مئوية ~ 125 درجة مئوية
  • RF Modulation Technique FSK
  • RF Carrier Frequency 433.920MHz±10kHz
  • FSK Deviation 60kHz
  • RF Baud Rate 9600bps
  • Radiated Power <-20dBm
  • LF Modulation Technique ASK
  • LF Carrier Frequency 125kHz±5kHz
  • LF Baud Rate 3900bps
  • Pressure Range 100~1500kPa
  • Battery CR2050HR

مظهر المنتج

Hiway-Integrated-Circuit-HW48244-tPMS-Sensor-fig-1

تثبيت

Ensure the TPMS sensor is compatible with your vehicle’s tire pressure monitoring system. Follow the manufacturer’s guidelines for installation.

الاقتران

After installation, pair the TPMS sensor with your vehicle’s monitoring system according to the system’s instructions.

يراقب

Regularly check the tire pressure and temperature readings on your vehicle’s display. Monitor any alerts or notifications regarding tire motion.

صيانة
Replace the sensor’s battery (CR2032) as needed. Keep the sensor clean and free from debris for accurate readings.

الأسئلة الشائعة

Q: How often should I check the tire pressure with the TPMS المستشعر؟
ج: يوصى بفحص ضغط الإطارات مرة واحدة على الأقل شهريًا أو قبل الرحلات الطويلة.

Q: Can I use the TPMS sensor on different vehicles?
A: The TPMS sensor is usually programmed for a specific vehicle and may not work on other vehicles without reprogramming.

Q: What should I do if the TPMS sensor battery needs إستبدال؟
A: Replace the CR2032 battery with a new one following the manufacturer’s instructions. Ensure proper disposal of the old battery.

المستندات / الموارد

Hiway Integrated Circuit HW48244 TPMS Sensor [بي دي اف] تعليمات
HW48244, 2BLDF-HW48244, 2BLDFHW48244, HW48244 TPMS Sensor, HW48244, TPMS Sensor

مراجع

اترك تعليقا

لن يتم نشر عنوان بريدك الإلكتروني. تم وضع علامة على الحقول المطلوبة *