شعار أجهزة الاستشعار الحيوي الديناميكي

Dynamic Biosensors helix cyto Normalization Solution

Dynamic-Biosensors-helix-cyto-Normalization-Solution-product

تحديد

  • اسم المنتج: heliX cyto Normalization Solution (Red Dye)
  • رقم الطلب: NOR-R2
  • For scIC measurements in the red channel
  • للاستخدام البحثي فقط
  • Limited shelf life – please check expiry date on label

الميزات الرئيسية

  • لتطبيع إشارات الفلورسنت على Spot 1 و Spot 2 من شريحة heliXcyto
  • Enables correct real-time referencing of the red fluorescent signals during scIC measurements
  • Compatible with all heliXcyto chips
  • The Normalization solution (red dye) contains a hydrophilic red dye with a single negative net charge.

وصف المنتج

  • رقم الطلب: NOR-R2

الجدول 1. المحتويات ومعلومات التخزين

مادة كاب Concentr ation كمية تخزين
Normalization solution-R2 أحمر 10 ميكرومتر 6 × 100 ميكرولتر -20 درجة مئوية
  • للاستخدام البحثي فقط.
  • This product has a limited shelf life; please see the expiry date on the label.
  • To avoid many freeze-thaw cycles, please aliquot the solution.

تحضير

  • Use this red dye normalization solution for scIC measurements in the red channel (analyte label-dependent).
  • Dilute the 10 µM normalization stock solution to a working concentration with running buffer.
  • The concentration of the normalization solution should approximately correspond to the fluorophore concentration in the highest analyte concentration to be measured. This can be calculated usingthe  following equation:

Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-1

  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-3 Concentration of the normalization solution in the desired color :
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-4تركيز الصبغة في المحلول التحليلي المسمى
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-5Highest concentration of the analyte that should be measured
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-6Degree of labeling (ratio of dye to analyte)

يمكن تخزين المحاليل المخففة عند درجة حرارة 2-8 درجة مئوية لمدة تصل إلى 7 أيام.

ملاحظة الطلب
In the scIC measurement, the fluorescent signal of the normalization solution should be in a similar range to the highest signal coming from the bound analyte (raw data). The absolute fluorescent signal is dependent on normalization solution concentration and the excitation power applied in the measurement. The excitation power has to be selected based on the following parameters:

  • Fluorophore concentration inthe  analyte solution
    يعتمد تركيز الفلوروفور على تركيز الحليلة المستخدمة في القياس وكذلك على درجة وضع العلامات على الحليلة. بالنسبة لارتفاع DOL وتركيزات الحليلة العالية، قد يكون من الضروري خفض قوة الإثارة.
  • إشارة ملزمة متوقعة
    Highly expressed targets on a cell can bind more molecules of the labeled analyte. In case of highly overexpressed targets, a strong binding signal can be expected. To avoid the shutter closing, lowering the excitation power might be considered.
  • نوع الرقاقة
    أنواع الرقائق المختلفة لها خلفيات فلورسنت مختلفة. كلما كانت المصائد أكبر وزاد عدد المصائد الموجودة على الشريحة، زادت إشارة الخلفية. لذلك، قد تتطلب شرائح L5 طاقة إثارة أقل من تلك المطبقة على شرائح M5.

For a starting point of excitation power and normSolution on concentration to be used in an scIC experiment, please refer to Table 2.
Table 2. Relation of fluorophore concentration, normalization solution concentration, and excitation power suitable for an Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-2 شريحة M5

تحليل صبغ conc. = التحليلة × دول قوة الإثارة حل تطبيع التركيز التخفيف التطبيع الحل
25 نانومتر 0.5 25 نانومتر 1:400
50 نانومتر 0.3 50 نانومتر 1:200
100 نانومتر 0.2 100 نانومتر 1:100
300 نانومتر 0.1 300 نانومتر 1:33
500 نانومتر 0.08 500 نانومتر 1:20
1 ميكرومتر 0.05 1 ميكرومتر 1:10
2.5 ميكرومتر 0.02 2.5 ميكرومتر 1:4

ملحوظة: This table is for your guidance. However, the final signal recorded in the heliXcyto depends on many factors. Thus, some optimization will be required for each system.

اتصال

أجهزة الاستشعار الحيوية الديناميكية GmbH
Perchtinger Str. 8/10 81379 Munich, Germany

شركة بروكر العلمية ذ.م.م
40 طريق مانينغ، مانينغ بارك، بيليريكا، ماساتشوستس 01821 الولايات المتحدة الأمريكية

www.dynamic-biosensors.com
صُممت وصنعت الأجهزة والرقائق في ألمانيا. ©2025 Dynamic Biosensors GmbH للاستخدام البحثي فقط. غير مخصص للإجراءات التشخيصية السريرية.

الأسئلة الشائعة

What is the shelf life of the heliX cyto Normalization Solution?

المنتج له مدة صلاحية محدودة. يرجى التحقق من تاريخ انتهاء الصلاحية الموجود على الملصق للحصول على معلومات محددة.

How should I store the NOR-R2 v1.0 product?

The product should be stored according to the storage information provided in Table 1 of the user manual.

Can I use this product for clinical purposes?

No, this product is for research use only.

المستندات / الموارد

Dynamic Biosensors helix cyto Normalization Solution [بي دي اف] دليل المستخدم
helix cyto Normalization Solution, helix cyto, Normalization Solution, Solution

مراجع

اترك تعليقا

لن يتم نشر عنوان بريدك الإلكتروني. تم وضع علامة على الحقول المطلوبة *