ACCUTIME HK4158AZ

ACCUTIME Hello Kitty LED Digital Quartz Watch for Kids

الموديل: HK4158AZ

مقدمة

This manual provides instructions for the ACCUTIME Hello Kitty LED Digital Quartz Watch, Model HK4158AZ. This officially licensed LED watch features a digital display and a Hello Kitty themed design. It is designed for children and offers easy time reading. Please read this manual carefully before use to ensure proper operation and longevity of your watch.

المنتج انتهىview

The ACCUTIME Hello Kitty LED Digital Quartz Watch is a battery-powered timepiece featuring a clear digital display. Its design incorporates the beloved Hello Kitty character on both the watch face and the strap.

  • عرض رقمي: Shows time in an easy-to-read LED format.
  • Hello Kitty Design: Features full Hello Kitty graphics on the strap and watch face.
  • بناء متين: Plastic case and strap, suitable for children's daily wear.
أمام view of the Hello Kitty LED digital watch, showing the red case, black display with red LED digits, and white strap with Hello Kitty design.

الشكل 1: الجبهة view of the Hello Kitty LED digital watch.

Image of the Hello Kitty LED digital watch worn on a child's wrist, showing the watch face and part of the strap.

Figure 2: The Hello Kitty LED digital watch on a child's wrist.

يثبت

Before using your watch, please follow these steps:

  1. التنشيط الأولي: If your watch has a plastic tab protruding from the side button, gently pull and remove it. This tab prevents battery drain during storage.
  2. التحقق من العرض: Press the button on the side of the watch. The time should illuminate on the LED display. If not, the battery may need to be activated or replaced (refer to Maintenance section).
جانب view of the Hello Kitty LED digital watch, showing the red case and white strap with the button on the side.

الشكل 3: الجانب view of the watch, highlighting the control button.

تعليمات التشغيل

Your watch has a single button for operation. The display will show the time for a few seconds and then turn off to conserve battery.

عرض الوقت

  • Press the side button once to display the current time.

ضبط الوقت

To set the time on your digital watch:

  1. Press the side button once to display the time.
  2. Immediately press and hold the button for approximately 3-5 seconds until the hour digits begin to flash.
  3. While the hour digits are flashing, press the button repeatedly to advance the hour. Release the button when the correct hour is displayed.
  4. After setting the hour, press and hold the button again for 3-5 seconds until the minute digits begin to flash.
  5. While the minute digits are flashing, press the button repeatedly to advance the minutes. Release the button when the correct minutes are displayed.
  6. The time is now set. The display will stop flashing and return to normal operation after a few seconds of inactivity.

صيانة

تنظيف

لتنظيف ساعتك، امسحها برفق بقطعة قماش ناعمة وجافة. تجنب استخدام المواد الكيميائية القاسية أو المواد الكاشطة، لأنها قد تُتلف طلاء الساعة أو شاشتها.

مقاومة الماء

مهم: هذه الساعة هي غير مقاوم للماء. Avoid exposing the watch to water, moisture, or high humidity. This includes showering, swimming, or heavy rain, as water damage is not covered under warranty.

استبدال البطارية

The watch is powered by one CR2032 (3V) battery. When the display becomes dim or stops working, it's time to replace the battery.

  1. Carefully turn the watch over to expose the stainless steel case back.
  2. Using a small screwdriver (not included), remove the screws securing the case back.
  3. Gently lift the case back to reveal the battery compartment.
  4. Remove the old CR2032 battery and insert a new one, ensuring the positive (+) side faces up.
  5. Replace the case back and secure it with the screws. Do not overtighten.

ملحوظة: Battery replacement should ideally be performed by an adult. Dispose of old batteries responsibly.

خلف view of the Hello Kitty LED digital watch, showing the stainless steel case back with product information and battery type.

الشكل 4: العودة view of the watch, showing the case back and battery information.

استكشاف الأخطاء وإصلاحها

مشكلةالسبب المحتملحل
Watch display is blank.Battery tab not removed or battery is dead.Remove the plastic battery tab. If already removed, replace the CR2032 battery.
الوقت غير صحيح.لم يتم ضبط الوقت بشكل صحيح أو إعادة ضبطه.Follow the "Setting Time" instructions in the Operating Instructions section.
الشاشة قاتمة.بطارية منخفضة.استبدل بطارية CR2032.

تحديد

ميزةالتفاصيل
رقم الموديلHK4158AZ
ماركةأكيو تايم
نوع العرضالصمام الرقمي
حركةكوارتز
مصدر الطاقةBattery Powered (1 x CR2032 3V)
مادة العلبةبلاستيك
مادة الحزامبلاستيك
قطر العلبة30 ملم
سمك العلبة10 ملم
عرض النطاق20 ملم
نوع المشبكمشبك تانغ
مقاومة الماءغير مقاوم للماء
المكونات المضمنةWatch, Battery, Strap
الفئة العمريةطفل

معلومات الضمان

This ACCUTIME Hello Kitty LED Digital Quartz Watch is backed by a one-year limited warranty from ACCUTIME Watch Corp. This warranty covers manufacturing defects under normal use. It does not cover damage resulting from misuse, accidents, unauthorized repairs, or water damage due to the watch not being water resistant. Please retain your proof of purchase for warranty claims.

يدعم

For further assistance or inquiries regarding your ACCUTIME Hello Kitty LED Digital Quartz Watch, please refer to the retailer where the product was purchased. For general product information, you may visit the official ACCUTIME webأو اتصل بقسم خدمة العملاء الخاص بهم إن وجد.

© 2023 ACCUTIME Watch Corp. All rights reserved. Hello Kitty is a registered trademark of Sanrio Co., Ltd.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.